8
Setting Up
The telephone requires four good quality non-recharable AAA
batteries. These are not supplied with your telephone. Carefully
remove the battery compartment cover-found on the underside of
the telephone base .We suggest using the tip of a ball point pen to
open the cover. Check the battery polarity diagrams when inserting
the batteries. Fit the battery cover back on.
Connect one end of the curly cord to the handset. The other end
of the curly cord plugs into the jack on the left hand side of the
PHOTOPHONE 450 unit marked
Handset Cord
. Place the handset
on the cradle.
Connect the line cord to the socket located at rear of telephone then
connect the plug into the wall socket**.
For the LCD display, backlight and other special features you must
use the power adapter (batteries act as a backup in case of power
failure). Connect the power adaptor to the jack located at the rear of
the telephone marked DC9V then plug the other end into a 13amp
mains power wall socket (*). Please choose a socket near your
telephone to enable you to unplug the mains power quickly in case
of a problem.
(*) Classified “hazardous voltage” according to EN60950 standard
(**) Classified TNV-3 according to EN60950 standard.
Wall Mounting
Rotate the handset hanger tab 180 degrees (see diagram 1).
This will keep the handset from falling out of the cradle when it
is mounted on the wall.
Knock two self-tapping screws (not supplied) into a wall at a distance
of 85 mm from each other and placed in a vertical line. Leave the
screws protruding from the wall by 6mm (see diagram 2).
Feed the guide tabs on the wall-mounting bracket into the slots at
the bottom of the telephone. Slide the bracket upwards until it
INSTALLATION
