Geekoala LP-56U-BT, Инструкция по эксплуатации

Страница: 9 / 13

1. A set of Line Out jacks is included to allow audio from BT, USB-MP3 and
PHONOGRAPH of this turntable to play on an external device.
2. Insert the audio cable (not included) into the turntable’s Line Out socket.
3. Operate the turntable as usual.
4. In order to achieve the best sound, it is advised to set the turntable volume to
a minimal level.
5. The turntable’s audio will then be played back through the external device.
It’s suggested to replace the stylus after400 hours of use.
Please follow the steps below to change the stylus:
1. Lift the tone arm off the tone arm lock.
2. At the front end of the tone arm, place the tip of your fingernail between the
red stylus holder and the black cartridge housing as shown. Press down down
on the red stylus holder until it separates from the cartridge housing.
3. Completely remove the red stylus holder with worn stylus and discard it.
4. Place the new red stylus holder with stylus under the cartridge housing. First
press upward on the back side of the stylus holder, and then press up on the
fron tedge of the stylus holder until it snaps into place on the cartridge
housing.
8
LINE OUT OPERATION
REPLACING THE STYLUS