Geeetech Prusa I3 X, Инструкция по сборке

Страница: 61 / 94

Shenzhen GETECH CO.,LTD
GEEETECH
57
X axis Fender on each rod> thread the X idler end to the end of the rod.
Step 3. Put the threaded rod into the coupling on both Z motor. You need to adjust the
place of the X motor and idler end on both end of X axis smooth rod so that the
threaded rod can fit into the couplings.
* Adjust the two end of the X axis to make sure the smooth rods and the threaded
rod of Z axis is vertical, and the two end of the X axis are horizontal , which is
very important, or it will hinder the move of the Z axis.
Step 4.Upon adjusting, thread the two L322mm smooth rod into both X motor end
and idler end. If the rod cannot smoothly get through the linear bearing,you can loose
the M4x16mm screws of the bearing.
Step 5. Thread the 1 locking ring to each L322mm smooth rod of the Z axis .
Step 6. Add the Z top mount to the Z axis. Screw it up with M3 x 16mm screw and
M3 Square nut.
Watch the video here .
17. Assemble the X motor
Part name Part ID Required number pic
stepper motor No.63 3
M3 x12mm screw No.22 12
Pulley No.42 1
Step1. Mount the pulley on the motor shaft, one of the screws should be screwed on