Swivel Arm Hoist
GEDA STAR 200 STANDARD / GEDA STAR 250 COMFORT
9.3.1 Free-standing tripod frame
The tripod frame is transported in three assemblies.
Assemble the tripod frame in the centre of the space. - Do not mount on the parapet edge
due to the risk of falling.
Lay both U-profile rails (1) in a triangle on
level ground.
Attach a ballast container (4) to this;
likewise, attach standpipe (2) with struts
(3). - The standpipe can be turned axially
by 180°, depending on which direction the
swivel arm is to be swung inwards.
Screw down standpipe (2) at bottom and
struts (3) at both ends (SW 24).
3
Assembly and Operating Manual
Page 17 of 38
BL107 GB Edition 01.2010
Fig. 8 Free-standing tripod frame
Suspend swivel arm hoist and secure with a linchpin.
Carefully push the entire tripod frame with
swivel arm hoist and ballast container (4)
to the parapet.
- Caution, danger of falling!
Load up the ballast container (4) with
4.0 kN (400 kg).
4
4
2
1
5
Fig. 9 Position the tripod frame
The swivel arm hoist is in principle operated from behind the side guide (5)!
