CONTROL ELEMENTS
CONTROL ELEMENTS
FRONT PANEL
1. POWER LED
Illuminates (red) when AC power is being supplied to the unit.
2. LEVEL / CLIP LED
Illuminates green when a signal is present. Illuminates red when the input signal level is within 6dB of
clipping. The input level should be adjusted so that the CLIP LED illuminates red occasionally on input signal
peaks. Continuous CLIP LED illumination means there is a risk of distortion and/or reduced DSP
performance.
3. POWER SWITCH
PUSH ON/PUSH OFF switch. To turn the unit ON, depress the switch until the POWER LED [1] illuminates.
Depress again to turn the unit OFF.
4. INPUT LEVEL CONTROL
Adjusts the input sensitivity for optimum matching with the input signal. The level should be adjusted so that
the CLIP LED illuminates red occasionally on input signal peaks. Failure to adjust the input level correctly
may caused increased distortion and degraded signal-to-noise performance.
5. DRY / WET MIX CONTROL
Adjusts from all DRY (full counterclockwise) to all WET (full clockwise) with variable mix in-between. The 12
o'clock position yields a 1:1 mix ratio.
NOTES:
An audible drop in signal level may occur at the 12 o'clock position due to
cancellation of certain frequencies that are out of phase.
6. OUTPUT LEVEL CONTROL
Adjusts the overall signal level available at the LEFT and RIGHT outputs.
7. PARAMETER 1 / PARAMETER 2 CONTROLS
Adjusts the selected variable as indicated in the EFFECTS LEGEND [9]. (Delay Time, Reverb Time, etc).
______________________________________________________________________________________
2
2
© GECKO MUSIC GROUP. All Rights Reserved.
1
2
3
4
5
6
7
8
9
