OPERATING & MAINTENANCE INSTRUCTIONS
INITIAL START-UP
WARNINGS
(MAY CAUSE SERIOUS INJURIES OR DEATH)
•
This pump is wired for 115 VAC, 60 Hz, and Single Phase power supply
ONLY. The power supply should be supplied through a Ground Fault Circuit
Interrupter (GFCI) with a rated tripping current not exceeding 5 mA.
CAUTION
(MAY CAUSE PROPERTY DAMAGE)
•
This pump is intended for
Jetted Bath use ONLY,
and is not suitable for any
other application.
•
The pump is NOT self-priming; therefore, the water fill - level of the jetted
bath must be equal or higher than the pumps suction port (inlet).
1. Fill the jetted bath with water to the normal operating bath water level.
2. Open all the valves within the plumbing system.
CAUTION
(MAY CAUSE PROPERTY DAMAGE)
•
DO NOT run the pump without water. If pump fails to prime within 30
seconds, turn it off. Check if there is an airlock, clogged plumbing, or closed
valve.
3. Turn the power supply “ON”.
4. If the pump has an air switch, depress the air button switch to turn the
pump “ON” or “OFF”.
5. Check plumbing system for leaks.
OPERATION
1. Fill the jetted bath with water to the normal operating bath water
level.
2. Depress the air button switch to turn the pump “ON”.
3. Depress again, to turn it “OFF”.
4. Be sure to drain the water from the jetted bath after each use.
MAINTENANCE
This pump does not require periodic cleaning or maintenance to perform
properly. It was designed and built to be trouble free. If, for some
reason, the pump leaks or fails to perform after completing the
troubleshooting procedure below, please contact your local
Authorized
Dealer
for assistance. If it is still under warranty, we will replace it free.
Содержание Aqua-Flo Therma-Flo Enviro-Heat Series
Страница 1: ......