Gearmore APL200, Руководство по сборке, эксплуатации и запасным частям

Страница: 4 / 55

1. Connect sprayer to tractor 3-point hitch.
2. Connect up the P.T.O. driveshaft, after you have checked to make sure the driveshaft is not
too long.
3. Check strainer screen, to make sure it is clean.
4. Check strainer shut-off valve, making sure the handle is in the open position.
5. Select transmission speed, if your sprayer is equipped with the air blast fan assembly.
6. Refer to calibration page to calibrate the sprayer. Set regulator pressure as required.
Important
- The pressure regulator adjusting knob must be unscrewed (turned to left)
as far out as possible before operating sprayer. Then gradually screw in (turn to right)
to desired pressure. Failure to operate in this manner could cause a sudden surge, which
could damage the sprayer. By sliding the control handle left towards the pressure gauge,
you can turn the valve one-half a turn to put the valve in bypass position. This would be
used for mixing chemicals, etc. It takes the pressure off the pump and sends the liquid
back to the tank. Turn the valve in the opposite direction for spraying. By sliding the handle
away from the pressure gauge, you can adjust the pressure setting by turning the valve.
7. Engage tractor P.T.O. and run for a couple of minutes to make sure the jet agitator has
mixed the chemicals thoroughly. Last, turn the control valve handles to the position required.
Either right hand, left hand or both sides spraying.
Remember, it is always best to make a practice run with water to be sure you have the
correct rates and coverage.
TO OPERATE SPRAYER
Page 2