Loosen screw
on each side
Toekick
Adjustable Panel
6
Installation Preparation
3 ADJUST RETAINING BRACKET
• Determine installation depth of the compactor
beneath the countertop.
• Adjust the position of the retaining brackets so
that the screws can meet the underside of the
countertop.
• Mounting clips are provided for stone or other
hard countertops that will not accept screws.
Retaining
bracket
Countertop
4 ADJUSTING THE BASE TOEKICK
A toekick extension is supplied. It can be used to
cover any gaps from the bottom of the compactor
to the floor. (See the
OPTIONAL STAINLESS
STEEL TOEKICK ASSEMBLY
section following
this step for available accessories.)
• Remove the toekick screws as shown. Lift off
toekick piece.
• Loosen the adjustable panel screws, adjust to
touch the floor and tighten the screws.
NOTE: If replacing with stainless steel assembly
accessories, remove the screws and lift off.
Install the new stainless steel toekick assembly
accessories.
• Reinstall the toekick piece with the original
screws.
5 POSITION COMPACTOR UNDER
THE COUNTERTOP
• Plug the power cord into a properly grounded
receptacle.
• Carefully lift the front of the compactor slightly
and roll the unit into the cabinet opening.
Lift here
When moving the compactor, use gloves to
protect and cushion your hands.
To protect the finished flooring, use a dolly
to move the compactor near the installation
location.
Failure to follow these instructions could result in
injury.
CAUTION
OPTIONAL STAINLESS STEEL
TOEKICK ASSEMBLY
Order on-line at
GEApplianceParts.com
, 24 hours
a day or by phone at
877.959.8688
during normal
business hours. To replace the included black toekick
assembly with a stainless steel toekick assembly,
order the following three parts:
Part Number
Accessory
WC17X10019
Kickplate - Stainless Steel
WC17X10011
Adjustable
Panel - Stainless Steel
WC17X10006
Toekick - Stainless Steel