Clock
To Set the Clock
The clock must be set for the
automatic oven timing functions to
work properly. The time of day
cannot be changed during a Timed
1. Press the
2. Press the INCREASE or
CLOCK
CLOCK pad.
DECREASE pad to set the
time of day. Press the CLOCK
pad to start.
Bake or CLEAN cycle.
Timer
To Set the Timer
The timer does not control
oven operations. The maximum
setting on the timer is 9 hours
and 55 minutes.
1. Press the
TIMER
TIMER pad.
2. Press the INCREASE or
DECREASE pad to set the
amount of time on the timer.
The timer will start automatically
within a few seconds of releasing the
INCREASE or DECREASE pad.
The timer, as you are setting it,
will display seconds until 1 minute
is reached.
Then it will display minutes
and seconds until 10 minutes
is reached.
After 10 minutes, it will display
minutes only until 59 minutes
is reached.
After 59 minutes, it will display
hours and minutes
now
appears in the display) until the
maximum time of 9 hours and
55 minutes is reached.
To Reset the Timer
To Cancel the Timer
If “TIMER” is displayed, press the INCREASE or
Press and hold the TIMER pad until the word
DECREASE pad until the desired time is reached.
“TIMER” disappears from the display.
If “TIMER” is not displayed, press the TIMER pad
first, then follow the instructions above to set the timer.
End of Cycle Tones
Display Messages
The end of cycle tone is 3 short beeps followed by
If
appears on the display, the door is not
1 beep that repeats every 6 seconds until you press
closed. If “LOCK” appears in the display, the oven
any operation. If you would like to eliminate the
door is in the locked position. BAKE, BROIL and
repeating beeps, press and hold the
pad
COOK TIME cannot be set if the door is in the
for 10 seconds.
locked position.
To return the signal that beeps every 6 seconds, press
and hold the
pad for 10 seconds.
Power
After a power outage, when power is restored, the display will flash and the
time shown will no longer be correct-for example, after a 5-minute power
interruption the clock will be 5 minutes slow. The display flashes until the
clock is reset. All other functions that were in operation when the power
went out will have to be programmed again.
7
