GEA Aseptomag ADV, Инструкция по эксплуатации

Страница: 42 / 68

10.6.3 Torques for clamp
Clamp screw thread size Recommended torque [Nm]
M6 10
M8 20
10.7 Disassemble and assemble actuator PA20 (side valve)
10.7.1 Disassemble actuator PA20 (side valve)
Tools required:
• Seeger circlip pliers
• Open end spanner
Caution!
Danger of injury due to spring force being released
You may be injured if the spring tension is released in an uncontrolled
manner, causing actuator parts to be moved or thrown around rapidly.
► Load and unload the spring in a controlled and slow manner.
► Wear protective gloves for all work.
► Always exercise caution and prudence.
Prerequisite:
•
The side valve actuator is disconnected from housing, see Section 10.6.1,
Page 38.
Carry out the following steps:
1. Bring the actuator to the non-actuated position.
2.
Loosen the elbow-connector with a suitable open-end wrench.
Fig.37: Remove the elbow-connector
3.
Place the actuator on firm ground and remove circlip with the Seeger ring
pliers.
Maintenance
Disassemble and assemble actuator PA20 (side valve)
430BAL012841EN_1
42 07.03.2018