ALCOVE OR CLOSET INSTALLATION
13
48 in.
2
(310 cm
2
)
24 in.
2
(155 cm
2
)
Closet door with vents
Side view
Front view
Installation Instructions
RUN THE WASHER THROUGH
A COMPLETE CYCLE
9
Check for water leaks and proper operation.
REMOVE THE PROTECTIVE FILM
COVERING THE CONTROL PANEL
10
It contains valuable and helpful information that will
save you time and money.
READ THE REST OF THIS
OWNER’S MANUAL
11
NOTE:
If your washer does not operate, please review
the
Before You Call For Service
section.
If your washer is approved for installation in an
alcove or closet, there will be a label on the back
of the machine describing requirements.
•
Minimum clearances between washer and adjacent
walls or other surfaces are: 0
″
(0 cm) either side,
1
″
(2.5 cm) front, 4
″
(10.2 cm) rear.
•
Minimum vertical space from top of washer to
overhead shelves, cabinets, ceilings, etc. is 17
″
(43.2 cm).
•
Closet doors must be louvered or otherwise
ventilated and have at least 72 square inches open
area for washer only, or if the closet contains both
a washer and dryer, doors must contain at least
144 square inches of open area equally distributed.
NOTE:
The clearances stated on this label are
minimums. Consideration must be given to
providing adequate clearances for installation
and servicing.
INSTALLATION CHECKLIST
8
Before starting the washer, check to make sure:
❏
Main power is turned on.
❏
The washer is plugged in.
❏
The water faucets are turned on.
❏
The unit is level.
❏
The drain hose is properly tied up.
❏
There are no leaks at the faucet, drain line
or washer.
PLUG THE POWER CORD
INTO A GROUNDED OUTLET
7
Insure proper ground
exists before use
3
″
(7.6 cm)
3
″
(7.6 cm)
17
″
(43.2 cm)
0
″
(0 cm)
0
″
(0 cm)
24
″
(61 cm)
22
1
⁄
2
″
(57.2 cm)
1
″
(2.5 cm)
4
″
(10.2 cm)
14
″
max.
(35.6 cm)