GE WLW3400S, Инструкция по использованию и уходу

Страница: 16 / 24

●
QUESTIONS?
USE THIS PROBLEM SOLVER
PROBLEM
POSSIBLE CAUSE
OR
●
sorting of clothes. Separate lint producers (such as towels and
ON CLOTHES chenille) lint receivers
(such as man-made fabrics, velveteen, corduroy).
●
Washing too long, especially for smaller loads. For normal wash minute
per pound of dry clothes.
●
Use non-phosphate detergents which combine with hardness to form
precipitate which can be mistaken for lint, Use a phosphate liquid detergent; use
warmer wash water or soften with an installed mechanical softener or a
packaged water softener.
●
Powdery residue from granular detergent may appear to be granular
detergent hot water before adding to washer; make sure detergent is completely
dissolved before adding clothes; switch to liquid or cold water detergent or
warmer wash water, See Detergent section.
●
Overloading will cause abrasion which creates excessive lint. Wash
with correct water level.
Too much bleach. Use correct amount of bleach according to package directions.
●
enough detergent to hold lint in suspension during wash cycle. Increase amount
of detergent. See Detergent section.
* use of fabric softener. used in wash may with
detergent to create a white deposit. Use softeners rinse cycle only unless package
specifies adding to wash cycle. See Other Laundry Products section.
●
Pilling usually on polyester-cotton blends is by normal wear and look
like lint. Turning clothes inside-out may provide
Static electricity caused by overdying will cause attraction. Use fabric softener
rinse cycle.
GREASY OR
These are sometimes called “Invisible Stains” because you may not notice them before
ON
washing clothes. However, if oily soils are not completely removed in wash cycle,
LAUNDERED
the oily spots may pick up dirt from the wash water. The spots be very visible.
GARMENTS They are caused the washer, Wash synthetic garments as soon as possible
wearing, Use more detergent than normal and hottest water fabric can stand.
appear, rub in undiluted liquid
let stand 30 minutes and rewash with extra
detergent using hottest water can stand.
GRAYED CLOTHES
●
Insufficient detergent. You may need to increase amount of detergent used if load is
larger normal, if soils are oily or heavier than average, if water level is large or if
water is Hard to Extremely Hard.
Water not hot enough for type of load. Be sure water heater is to water to
the washer at not wash other hot water
such as or family baths—are heavy.
●
Poor or inferior detergent, Change to phosphate if possible. these steps:
1. Use water conditioner (such as brand).
2. Pretreat stains.
3. Use the hottest water possible.
4. Use bleach where possible.
5. Use presoak aids.
water softener.
Washer overloaded. Clothes cannot move freely to and remove soil, causing
gray appearance. Follow correct loading procedures for size of
16