GE WCCB1030WYC, Техническое обслуживание руководство

Страница: 14 / 35

13
BOTTOM
TABS
ROTATE FRONT PANEL
OUT AND LIFT OFF TABS
TO REMOVE
LOCATE SPRING CLIPS
ON EITHER
SIDE AND RELEASE
WITH PUTTY KNIFE
LOCATE AND RELEASE
TWO SPRING CLIPS
Cabinet
Cabinet is galvanized sheet metal, with powdered
paint coating and is rust resistant. It has a fully en-
closed bottom, and is 3 sided with a front panel.
The lid has a patented colored lid instruction that is
unique to each model. Proper lid should be used to
replace a lid, so that the correct instructions stay
with the washer. The levelling legs are installed from
the factory, and are Polypropylene with Santoprene
non-skid base. Base of levelling legs have a 1” hex
nut design to allow easy adjustment if necessary.
Rear is self levelling, and is accomplished by lifting
the rear legs 4” off the floor and lowering the washer.
To Service Front Panel:
1. Locate the two spring clips between cover and
front panel and cover.
2. Insert putty knife and push to release clips.
3. Rotate front panel forward and lift off cabinet base
locating tabs.
4. To reassemble, place front panel on washer base
locating tabs, rotate up into place and press top of
panel at clips, until panel snaps into place.
To Service Cover/Lid Assembly:
1. Remove front panel.
2. Remove two 1/4” hex screws front left and right
side of cabinet top support.
3. Pull cover/lid assembly towards you and up about
2”.
4. Release lid switch wire connector, wires are or-
ange/
orange white. Connector is located in right rear cor-
ner of cover, you ay need to press down on wiring
to allow clearance to remove connectors.
5. Remove covver/lid assembly, taking care not to
allow lid to swing out and be damaged.
6. Reverse steps to reassemble.