GE Voluson P8, Базовое руководство по обслуживанию

Страница: 95 / 620

GE DRAFT V
OLUSON
™ P8/V
OLUSON
™P6
DIRECTION 5775469, R
EVISION
3 DRAFT (J
ULY
19, 2018) B
ASIC
S
ERVICE
M
ANUAL
Chapter 3 - Setup Instructions 3-27
3-6-2-3 During a normal boot, you may observe
A.) Power is distributed to Peripherals, Operator Panel (control panel), Monitor, Front-End and
Back-End Processor.
B.) The Back-End Processor and rest of the System starts with the sequence listed in following steps:
1.) First of all, the BIOS version is shown on the monitor.
2.) Afterwards the “Boot Screen” is displayed. (
Voluson is highlighted, Figure 3-15 below).
3.) Back-End Processor is turned ON and starts to load the software.
4.) The Start Screen (Voluson™ P8/Voluson™P6) is displayed on the monitor.
5.) Start-up progress bars indicating software loading procedures, are displayed on the monitor,
as shown in Figure 3-16 below.
6.) The software initiates and sets up the Front-End electronics and the rest of the Ultrasound unit.
7.) The Keyboard backlight is lit.
8.) As soon as the software has been loaded, the 2D screen is displayed on the monitor.
Figure 3-15 Boot screen
Figure 3-16 Start-up screen