GE Vivid S60N, Базовое руководство по обслуживанию

Страница: 249 / 478

D
IRECTION
FR091521, R
EVISION
1 V
IVID
S60N/V
IVID
S70N B
ASIC
S
ERVICE
M
ANUAL
Chapter 8 - Replacement Procedures 8-19
P R E L I M I N A R Y
8.) Unfasten the three securing screws shown in Figure 8-15 and remove the rear part of the RS cable
assembly from the top of the electronic cage.
8-2-8-5 Front Cover Installation Procedure
NOTE: The RS cable assembly has two parts - front and rear.
1) Fit the rear part of the RS cable assembly to the top of the electronic cage and secure firmly in
position with the three screws - see Figure 8-15 .
2) Return the front cover to its original position, aligning the lower portion with the base of the
mechanical platform. Make sure the wheel arch cutouts are positioned correctly on either side.
3) Push the upper portion of the cover back into position.
4) Return each of the two screws (previously removed) to the securing tabs on either side of the cover
and tighten securely.
5.) Place the front part of the RS cable assembly in the correct position, then use the two securing
screws to fasten it to the rear part. Close the slider. Refer to Figure 8-13 on page 8-18 .
6) Install the DVD, right side and left side covers.
Figure 8-15 Removing the RS Cable Assembly - Rear Part
• DVD Cover Installation Procedure on page 8 - 12
• Right Side Cover Installation Procedure on page 8 - 10
• Air Inlet (Left Side) Cover Installation Procedure on page 8 - 8