GE Vivid S5 N, Руководство по обслуживанию

Страница: 480 / 834

GE
P
ART
N
UMBER
FN091065, R
EVISION
2 VS5 N
AND
VS6 N
S
ERVICE
M
ANUAL
7-96 Section 7-5 - Monitoring Tests
P R E L I M I N A R Y
7-5-1 Accessing the Monitoring Diagnostic Test Options
(cont’d)
17.)Check that the sub-test passed and that result values are within the pre-defined Max and Min limits,
as shown in Figure 7-64 "View Test Log - Full System Monitoring Test - Tx Voltages" on page 7-96 .
18) When done, trackball to the Exit button and press Set to close the View Report window.
19) After reviewing the test results, proceed as follows:
• If no problems were identified, it is recommended to re-boot the system (this is obligatory when
prompted).
• If no problems were identified but the problem persists, contact your local GE HEALTHCARE
field engineer for assistance.
• If errors were identified but the results were marginal, perform calibration, as described in
“DC Offset Calibration” on page 7-27 , and then repeat the test.
• If errors were identified and the results were not marginal, verify that all system cables and
boards are connected (not misplaced) and functioning properly, as described in Chapter 5 -
Components and Function (Theory) .
If the problem persists, this indicates that either the specific board you tested is faulty or that
another board that supports the operation of that board is faulty. Contact your local
GE HEALTHCARE field engineer for assistance.
20.)Trackball to the Exit button and press Set to close the View Test Log dialog box.
21.)Press the < Esc > button on the keyboard to close the Diagnostic Test Window .
Figure 7-64 View Test Log - Full System Monitoring Test - Tx Voltages