GE Vivid in, Руководство по обслуживанию

Страница: 581 / 740

GE H
EALTHCARE
D
IRECTION
FQ091013, R
EVISION
1 V
IVID
I
N AND
V
IVID Q
N S
ERVICE
M
ANUAL
Chapter 8 - Replacement Procedures 8-53
8-3-8 LCD Display Replacement Procedure
8-3-8-1 Tools
Use the appropriate Phillips and flat screw drivers, as indicated in the LCD Display replacement
procedure.
8-3-8-2 Time Required
15 minutes
8-3-8-3 Preparation
Shut down the Vivid i n/ Vivid q N ultrasound unit, as described in - System Setup .
8-3-8-4 LCD Display Removal Procedure
1) Remove the bearing handle, as described in the Bearing Handle Removal Procedure on page 8 - 3 .
2) Remove the Control Panel and Keyboard as described in the Control Panel and Keyboard Removal
Procedure on page 8 - 9 .
3.) Remove the LCD Display Frame as described in the LCD Display Frame Removal Procedure on
page 8 - 27 .
4.) Loosen and remove the four screws that fasten the LCD Display to the Rear Cover & Latch
Assembly, as shown in shown in Figure 8-62 below .
5.) Disconnect the LCD Flex ribbon cable from the BEP, as shown in Figure 8-63 below .
Use a flat screwdriver to carefully release the cable from the connector.
Figure 8-62 Removing the Screws from the LCD Display
Figure 8-63 Disconnecting the LCD Flex Ribbon Cable