GE VE1012 Series Скачать руководство пользователя страница 4

Страница: 4 / 20

4. Wire the detector (see Figures 4 and 7).
5. Select the desired jumper and DIP switch settings (see

Figure 3). See section “Jumper settings” below for more
information.

6. Remove the blinders and add the stickers, if required (see

Figure 6 for an example).

7. For ceiling-mount applications that require a 90° coverage,

use the SB01 swivel-mount bracket.

8. Close the cover.
9. Insert the screw and place the custom insert.
For EN 50131 grade 3 installations, do not use mounting
position C.

Jumper settings

See Figure 3 for the jumper locations in the detector.

J1: Not used

J2: PIR enabling the LED

On: Enables the detector LED at all times (default)
Off: Puts the LED under control of the control panel and
disables the detector LED at all times (no memory feature)

J3 and J4: Dual loop setting

This sets the alarm and tamper relays. It allows you to connect
the detector to any control panel. Use jumpers 3 and 4. See
Figure 7.

J5: D/N mode (Day/Night) or Rtest (remote test) setting

Use this jumper to set terminal 8 to either D/N or Rtest.
GE Security recommends that you use D/N to manage the
AM/TF activation when required. Use Rtest to test the detector
from the control panel. The detector will activate the Alarm
relay if the test result is positive, and the AM relay if the test
result is negative.
On: Terminal 8 = D/N (default)
Off: Terminal 8 = Remote test

J6: Polarity setting of the control voltage (CV)

On: “Active High” provides the standard GE Security logic with
“Active High” logic to enable Walk Test (WT) and Day/Night
inputs (default)
Off: “Active Low” provides “Active Low” logic to enable Walk
Test and Day/Night inputs

Setting the detector: DIP switch setting

See Figure 3, item 1.

SW 1: When to signal AM (anti-masking) or TF (technical
fault) output

On: Signals AM or TF only when the system is in Day mode
(default)
Off: Always signals AM or TF during Day and Night mode

SW 2: AM sensitivity

On: Selects a higher level of AM sensitivity. AM relay reacts
within 6 seconds.
Off: Selects the standard AM sensitivity. AM relay reacts within
12 seconds (default).

SW 3: Resetting the AM/TF output

The system will only reset an AM alarm if it has ensured that
the cause of the AM alarm has been removed. If the AM

circuitry cannot return to its original reference levels, then
either the detector is still masked or possibly has been
damaged. The owner should then visually check that the
detector is still fully functional.
On: Resets the AM or TF status 40 seconds after a PIR alarm.
Off: Resets the AM or TF status after a PIR alarm when the
system is in Day and Walk Test status. The yellow LED will
blink quickly. When the system is in Night status, the yellow
LED will turn off and the system is reset (default).

SW 4: Signaling AM or TF output

On: Signals AM on both the AM and Alarm relays. Signals TF
on the AM relay only (EN 50131)
Off: Signals AM and TF on the AM relay (default)

SW 5: Setting LEDs

On: Enables both LEDs on the detector at all times (default).
Off: Puts both LEDs under the control of the Walk Test and
Day/Night input. This activates the memory feature of the
detector.

LED indication

PIR Red

LED

Yellow
LED

Alarm
relay

AM
relay

To reset

Start up

Closed

Automatically
after 25 s

Low voltage

Open
(Alarm)