background image

Sensor low battery. 

This condition occurs if a system sensor has a low battery. The 

sensor may still be communicating with the panel. Trouble beeps will start and the 

STATUS

 button will light. Press the 

STATUS

 button and the display will show what 

sensors have a low battery. You may need to call your security system dealer to resolve 
this problem. Some sensor batteries can be replaced by the homeowner.  

Fail-to-communicate. 

This condition occurs if your security system cannot 

communicate to the central monitoring station. Your system will try to report to the 
central monitoring station eight times before it tells you there is a fail-to-communicate 
problem. Trouble beeps will start and the 

STATUS 

button will light. Press the 

STATUS 

button and the display will show 

Comm Test Fail

 or 

Comm Failure

. You may need to 

call your security system dealer if the problem continues. 

Sensor open

. This condition occurs if a door or window is open or a system sensor has 

been disturbed and not reset properly. For example, a door/window sensor magnet may 
have been removed from the sensor. Your system will indicate this condition to you by 
causing the 

STATUS

 button to light. When you press the 

STATUS

 button, the display 

shows, for example, Sn 1 Front Door Open. Correct the problem by resetting the 
sensor. If this condition continues, call your security system dealer. 

Sensor tampered

. This condition occurs when a sensor is physically tampered with, for 

example, the cover is taken off of one of the sensors. If the system is armed an alarm 
will occur. Your system will indicate this condition to you by causing the 

STATUS

 button 

to light. Trouble beeps will start. Press the 

STATUS

 button and the display shows 

Sn #

 

Name Tampered

. Correct the problem by resetting the sensor. If this condition 

continues, call your security system dealer. 

RF jam detected.

 The panel receiver may be experiencing some interference. The 

system will call to notify the central monitoring station about this problem. 

Clearing status

. Some types of status conditions, such as the alarm history, must be 

cleared manually. To clear system status, press the 

STATUS

 button, read and/or listen 

to the status messages, then press 

DISARM

. If the trouble condition was a low system 

battery, perform a sensor test. The 

STATUS

 light should turn off if all trouble conditions 

have been corrected. 

Отзывы: