GE SC2, Инструкция по использованию и уходу

Страница: 7 / 12

7
REVERSING THE DOOR SWING
(on some models)
1. Remove the top hinge cover and loosen and
remove the two screws holding the top hinge in
place.
2. Lift the door up and off the bottom hinge pin.
3. Loosen and remove the leg and two screws
from the bottom hinge.
4. Remove the leg from the left side of the
cabinet.
5. Remove and transfer the bottom hinge to the
left side without flipping or turning it. Lift and
transfer the bottom hinge pin to its adjacent hole.
6. Install the leg (removed from the left side) to
the right side of the cabinet.
7. Place the door over the bottom hinge pin and
guide the door bottom hole to the pin.
8. Remove the two plugs from the top left side of
the cabinet. Place the top hinge over these holes
and the hinge pin into the hole on top of the
door. Drive the screws into the top of the
cabinet. Do not tighten until the door is checked
for proper gasket seal alignment. Insert two new
plugs into the holes in the top right side of the
cabinet.