Learning Function
The learning feature is used as a supplement to the stan-
dard preprogrammed library. the standar code library
provides most of the functions needed,, but you can add
additional functions from your original remote. Note:
No functions may be stored under the LEARN, SLEEP,
SETUP, MENU or any of the device buttons.
1. Place the remote control unit and the original remote
control unit so the
bottom end of the
24973 remote (infrared
receiver) faces the top
end (infrared trans-
mitter) of your orginal
remote. They should
not be any more than
2 inches apart.
2. Press and hold the
SETUP
but-
ton until the
INDICATOR LIGHT
lights, then release the
SETUP
but-
ton.
3. Press and release the desired
Mode button (
TV, VCR, DVD
,
etc. . . .) The
INDICATOR LIGHT
will blink off once button press is
accepted.
4. Press and release the
LEARN
button.
5. Press and release the button to
be learned on this remote. Any
button (except, LEARN, SETUP,
MENU, OR device buttons) can be
used to store learned functions.
6. Press and hold the button on
the original remote control until
INDICATOR LIGHT
on this
remote blinks once. Once the
INDICATOR LIGHT
blinks
you may continue with the next
function. If there is an error in
learning the new function the
INDICATOR LIGHT
will flash
for 3 seconds but remain in the
learning mode. Return to step 5 if
the
INDICATOR LIGHT
flashed.
NOTE: Hold the function key on your
original remote for at least 3 seconds
for the command to be successfully
learned.
7. Repeat steps 5 and 6 to store more
functions.
8. Once the selected functions are
stored press the SETUP button and
the remote will return to original
operation mode.
9
2 inches
BLINK
