6
49-5000416 Rev. 0
NETWORK INSTALLATION ONLY
NOTE:
This section is not required unless the thermostats
are networked
Pairing the Thermostat and the Control Card:
In case of Network Installation with online
management, the thermostat and the Control
Card must be paired with a Network Programmer
specific to the property before the installation. Note:
Thermostat and Control Card are factory paired.
The thermostat and control card must not be powered
during the pairing procedure - remove batteries from the
thermostat and unplug the control card from the HVAC
unit during the pairing procedure.
• Plug one programmer connector into the thermostat;
• Plug the other programmer connector into the control card.
• Push the black button on the programmer.
• The red light on the programmer should turn on and
remain steadily lit.
• If the red light on the programmer is blinking or is not
steadily lit, unplug the programmer from the thermostat
and the control card and repeat the steps above.
• Unplug the programmer from the thermostat and the
control card.
Thermostat
Network
Programmer
Programmer
Connector
Control
Card