INSTALLATION INSTRUCTIONS
Open the Wink app on your mobile
device and log in with your email
address and password. If this is
your first time using the Wink app,
tap Sign Up to create an account.
Follow the steps provided in the
Wink app.
The white LED lights on the
buttons will blink when pairing. The
pairing mode will last 60 seconds.
To restart the pairing mode, press
and hold both buttons on Tapt at
the same time for 5 seconds. The
lights will start blinking.
When the Wink app displays
“success,” your device is
connected. The white LED light on
the top right of each button will be
solid ON when paired, then turn
off after a few seconds.
1 Turn OFF power at the circuit breaker that
controls the light switch. It is recommended
to use a circuit tester to make sure the circuit
is off.
2 Remove existing wall plate and light switch.
3 Identify the line, load, ground and neutral
wires. IF THERE ARE NO NEUTRAL WIRES,
STOP AND CONSULT AN ELECTRICIAN.
4 If neutral is present, disconnect the wiring
from the existing switch.
5 Connect Tapt assembly wiring with included
push-in wire connectors. A push-in wire
connector works as a ‘finger trap’ for wires;
simply push wires into an available pole to lock.
Connect as follows:
GREEN
wire on switch to green/bare
GROUND
wire
WHITE
wire on switch to white
NEUTRAL
wire
BLACK
wire on switch to black
LINE
wire
RED
wire on switch to red
LOAD
wire
NOTE: Your home’s wiring may differ;
please consult an electrician.
6 Double-check to confirm wiring is correct.
7 Place Tapt assembly into wall and mount using
the mounting screws from the existing switch.
8 Use the included faceplate or attach your
existing wall plate:
To use the included faceplate:
Press the faceplate onto the snap plate.
To use your existing wall plate:
Unscrew the smaller top and bottom screws
on the assembly and remove the snap plate.
Attach your wall plate only.
NOTE: The included faceplate and snap plate
are intended for single gang box installations
only. If installing in a double gang box, use a
double gang wall plate (not included) without
the faceplate and snap plate.
9 Turn on power at the circuit breaker.
10 There is a white LED light on the top right
of each switch button that will turn on when
pressed. Press each button to make sure
Tapt is wired correctly.
11 If the lights are not working, be sure to turn
off power at the circuit breaker before you
fix the wiring.
CONNECTING TAPT TO THE WINK APP
Tapt should be installed by a qualified electrician and used in accordance with appropriate electrical codes and regulations.
This is a single pole switch and neutral connection is required. Not intended for replacement of 3-way switches.
