13
MOUNT THE OVEN
A4
ASSEMBLE AND INSTALL ADAPTOR
A3
USE TOP CABINET TEMPLATE FOR
PREPARATION OF TOP CABINET
You need to drill holes for the top support screws,
a hole large enough for the power cord to fit through,
and a cutout large enough for the exhaust adaptor.
A2
Damper
Back of
Oven
Read the instructions on the TOP CABINET TEMPLATE.
Tape it underneath the top cabinet.
Drill the holes, following the instructions on the TOP
CABINET TEMPLATE.
CAUTION:
Wear safety goggles when
drilling holes in the cabinet bottom.
Installation Instructions
Place the oven in its upright position, with the top
of the unit facing up.
Insert the tabs on each side of the damper into
the holes at the inside rear of the adaptor.
Attach the exhaust adaptor to the blower plate with
the two bronze metal screws provided.
0DNHVXUHWKDWWKHGDPSHUSLYRWVHDVLO\EHIRUH
PRXQWLQJRYHQ
You will need to make adjustments to assure proper
alignment with your house exhaust duct after the
oven is installed.
Exhaust
Adaptor
1
2
Blower Plate
3
CAUTION:
7RDYRLGWKHULVNRISHUVRQDO
LQMXU\EDFNLQMXU\RURWKHULQMXULHVGXHWRH[FHVVLYH
ZHLJKWRIWKHPLFURZDYHRYHQRUSURSHUW\GDPDJH
\RXZLOOQHHGWZRSHRSOHWRLQVWDOOWKLVPLFURZDYH
RYHQ
IMPORTANT:
Do not grip or use handle during
installation.
WARNING:
5LVNRI(OHFWULF6KRFN&DQ
cause injury or death: If installing unit with metal
FRXQWHUWRSVFRYHUWKHHGJHRIWKHSRZHUVXSSO\
cord hole with the power supply cord bushing.
IMPORTANT:
If filler blocks are not used, case damage
may occur from overtightening screws.
Tur
n to Select
P re s s to E
nte
r
Insert a self-aligning screw through top-center
cabinet hole. Temporarily secure the oven by
turning the screw at least
two full turns
after
the threads have engaged
.
(It will be completely
tightened later.)
3
NOTE:
When mounting
the microwave oven,
thread power cord through
hole in bottom of top
cabinet. Keep it tight
throughout Steps 1–3. Do
not pinch cord or lift oven
by pulling cord.
Lift microwave oven,
tilt it forward, and hook
slots at back bottom
edge onto four lower
tabs of mounting plate.
1
2
Rotate front of oven up
against cabinet bottom.
