PSI23SCR – GE Profile CustomStyle
™
22.6 Cu. Ft. Side-by-Side Refrigerator with Icemaker
TM
An enclosure is
required
to match up to the trim, see Typical
Installation. To obtain the most integrated look, the cabinet or
soffit above the refrigerator should extend out to the same depth
as the side panels. The refrigerator opening must have minimum
dimensions of 70-1/4" high x 36-1/8" wide x 24-1/2" deep as shown
at right. If there is an overhead cabinet, allow 1" for cabinet
door clearance with the top trim piece so the cabinet doors can
be opened without hitting the top trim. If 1/2" side panels are
used, then side trim and panel will be even. If 3/4" side panels
are used, then some of the side panel will extend beyond the
trim and must be finished.
Collar Trim Installation
Refer collar trim install
Overhead
Cabinet
Cabinet
Door
Top Trim
Case
1"
Magnetic
Tape
3/4" Cabinet
Side Panel
1/2" Cabinet
Side Panel
Side trim must be installed
flush with the gasket contact
surface on the case.
Refrigerator
Case
Side Trim
Door Gasket
IMPORTANT:
Before finalizing specifications for
your GE Profile CustomStyle Refrigerator, please
NOTE:
• A minimum of 36-1/8" is required for
refrigerator installation with collar
• Be sure to allow for 1/2" or 3/4" side panels
in addition to the 36-1/8" minimum
70-1/4"*
36-1/8"
24-1/2"*
1/2" minimum
*The rough-in dimension of 70-1/4" is minimum and is measured from the
finished floor to top of opening (or the underside of the overhead cabinets).
For Models with Trim Kit: If frameless style cabinets are planned for above the
refrigerator, you may need to consider adding a maximum of 1/4" (70-1/2") to
height of opening to allow additional clearance between cabinet doors and
top of refrigerator trim when cabinet doors are in open position.
Collar Trim Installation Art
R
Total volume and shelf
area are calculated by
the Association of Home
Appliance Manufacturers’
standards.
Listed by
Underwriters
Laboratories
Typical Installation
Shaded areas represent front surfaces of side panels
and overhead cabinet or soffit that contacts trim.
For answers to your Monogram,
®
GE Profile
™
or
GE
®
appliance questions, visit our website at
GEAppliances.com or call
GE Answer Center
®
service, 800.626.2000.
Specification Revised 7/05
210214
R
