Good
Starts with HOT Water
To
dishes clean and dry, you need hot water. For good washing and drying,
the entering water must be at least
To prevent dish damage, inlet water should not exceed
How to Test Water Temperature
Check your water temperature with a candy or meat
Helpful hints: outside temperatures are unusually
thermometer. Turn on the hot water
nearest
low, or your water travels a
distance from
the dishwasher. Put the thermometer in a glass and
heater to dishwasher, you may need to set your water
let the water run continuously into the glass until the
heater’s thermostat up. you have not used hot
temperature stops rising. the water temperature is
some time, the
in
pipes will be cold. Turn
below 1200 F., adjust your water heater.
on the hot water
at the sink and allow it to run
until the water is hot. Then start the dishwasher.
you’ve recently done laundry or run hot water
showers, give your water heater time to recover
operating the dishwasher.
To improve washability the water is less than
you cannot adjust your water heater: Select
a longer cycle or the WASH HEAT BOOST option
fill both detergent cups at least half-full with detergent.
How to Use a Rinse Agent
The rinse agent makes water
dishes
quicker than usual. This lessens water spotting
and makes drying faster, too.
For best
performance, use of a rinse
agent such as JET-DRY brand is recommended.
Rinse agents come in either liquid or solid form.
Your dishwasher uses the liquid form.
How to fill the rinse agent dispenser.
Unscrew the cap.
Add liquid rinse agent
until it just reaches the
bottom of lip inside the
dispenser opening.
Replace cap. The
dispenser automatically
J
releases rinse agent into
rinse water.
Your dishwasher’s rinse agent container holds
approximately
ounces. This
last about
months. Fill as needed.
If you accidentally spill: Wipe up the rinse
with a damp cloth. Don’t leave the spill in the
dishwasher. It can keep your detergent from working.
If you can’t find any rinse agent, write:
CONSUMER PRODUCTS,
( “JET-DRY”)
Corporate Centre I
55 Federal
Box
Danbury, CT 06813-1991
You may check to see you need to add rinse agent by
removing the fill
and looking into the container.
You
check the rinse agent, on some models,
by pressing the
center
of the
cap 2 or 3 times.
rinse agent is drawn into the center of the fill cap,
you have enough. the center area remains clear add
rinse agent.
