❒
CUTOUT DIMENSIONS
1
2
* Min. depth with receptacle outside cabinet 19
1
⁄
2
″
Min. depth with receptacle inside cabinet 22
″
120 volt-60 Hertz grounded power receptacle
Installation Instructions
Models
27
″
30
″
Height
16
3
⁄
4
″
16
3
⁄
4
″
Width
25
1
⁄
2
″
25
1
⁄
2
″
Depth (min.)*
19
1
⁄
2
″
or 22
″
19
1
⁄
2
″
or 22
″
WARNING
—
This trim kit uses air
flow from the top, bottom and sides of the trim
frame. Blocking the air flow can cause the microwave
to function improperly and may cause damage to
the microwave.
Allow a 1
″
clearance beyond the edge of the trim
frame to provide proper air flow.
On 27
″
models, allow 1
1
⁄
8
″
at the top,
11
⁄
16
″
on the
sides and 1
1
⁄
4
″
at the bottom for overlap of the Trim
Frame over the edges of the cutout.
On 30
″
models, allow 1
1
⁄
8
″
at the top, 2
1
⁄
16
″
on the
sides and 1
1
⁄
4
″
at the bottom for overlap of the Trim
Frame over the edges of the cutout.
FOR INSTALLATION ABOVE A
BUILT-IN OVEN:
Microwave oven should be installed on a 3/8
″
plywood base and supported by 2x4 or 1x2 equivalent
runners on all sides. Base must be capable of
supporting a minimum of 100 lbs.
Draw a line on the cutout floor at the center of
the cutout, and extend the line 1/2
″
down the
face of the cabinet.
Draw a line on the top front face of the cabinet
at the center of the cutout. The line should extend
1/2
″
up the face of the cabinet. This center line will
be used for mounting the top bracket (see step 7).
Fold or cut the front edge of the template, along
the front guide line. Place the template flush
along the front edge of the cutout floor, aligning
the center line of the template with the center line
of the cutout floor. Mark the center positions with
an awl or center punch for the anti-tip brace
location as shown.
Drill two holes for the anti-tip brace.
Install the anti-tip brace onto the cutout floor
using two round-head screws.
B
C
D
E
D
D
Round-head screws (2)
Anti-Tip Brace
❒
INSTALL THE ANTI-TIP BRACE
2
Depth
Height
1
1
⁄
4
″
Overlap
Width
1
1
⁄
8
″
Overlap
1
″
Clearance beyond
trim frame
(on all sides)
3
″
Min.
27
″
Models:
11
⁄
16
″
overlap
30
″
Models: 2
1
⁄
16
″
overlap
A
DIMENSIONS:
A = 1
1
⁄
2
″
B = 3
″
C = 18
3
⁄
16
″
D = 1/2
″
Bottom of trim kit
must be minimum
of 36
″
from floor
