background image

PART

QUANTITY

❒ 

Trim Frame

1

❒ 

Bottom Duct

1

❒ 

Side Duct

1

❒ 

4 mm x 12 mm 

23

Round-Head Screws (21 required 

for installation)

❒ 

4 mm x 14 mm 

6

Flat-Head Screws

(4 required for 
installation)

❒ 

Anti-Tip Brace 

1

❒ 

Anti-Tip Bracket 

1

❒ 

Upper Duct 

1

❒ 

Top Bracket

1

❒ 

Bottom Bracket

1

❒ 

Templates

2

PARTS INCLUDED

Questions? Call 800.GE.CARES (800.432.2737) 

or

Visit our Website at:

ge.com

READ CAREFULLY.  
KEEP THESE INSTRUCTIONS

.

Installation 

Built-In Trim Kits

Instructions

JX2027 and JX2030

Read these instructions completely and carefully.

IMPORTANT –

Save these instructions for local

inspector’s use.

IMPORTANT –

Observe all governing codes and

ordinances.

Note to Installer –

Be sure to leave these instructions with the

Consumer.

Note to Consumer –

Keep these instructions for future reference.

For easier installation and personal safety, we recommend that two people
install this microwave oven.

WARNING

This oven must be plugged into a properly

grounded 3-hole, 120V receptacle as required by the National Electrical Code.

❒ 

BEFORE YOU BEGIN

• 

Do not alter or modify any part of this kit or the oven.

• 

Unplug the microwave oven before attempting installation of this kit.

• 

Skill level

– Installation of this appliance requires basic mechanical and

electrical skills.

• 

Completion time

– 1-3 hours

• 

Proper installation is the responsibility of the installer. 

• 

Product failure due to improper installation is not covered under the Warranty.

• 

This kit is UL listed for installation alone or over any GE/GE Profile 
single electric wall oven. Not for use adjacent to (within 2 feet of) any gas
or electric range, cooktop or oven.

• 

This kit is for use on models: PEB2060DMBB, PEB2060DMWW,
PEB2060DMCC, PEB2060SMSS, JEB1860DMBB, JEB1860DMWW,
JEB1860DMCC and JEB1860SMSS.

TOOLS YOU WILL NEED

❒ 

Phillips screwdriver

❒ 

Pencil

❒ 

Tape measure

❒ 

Awl or punch

❒ 

Drill with 

7

64

bit or #35

FOR YOUR SAFETY:

WARNING –

Before beginning the

installation, switch power off at service panel and lock
the service disconnecting means to prevent power
from being switched on accidentally. When the service
disconnecting means cannot be locked, securely fasten
a prominent warning device, such as a tag, to the
service panel.

❒ 

Level

❒ 

Scissors (optional)

1

NOTE:

This kit has extra screws to prevent the technician from spending extra

time locating a replacement screw in case they lose one during installation.

Отзывы: