��������
��������
��������
���������
STEP 3 – CHECK DOOR BALANCE
• With dishwasher on the wood skid, check the door balance
by opening and closing the door.
• If the door drops when released, increase the spring tension.
If the door rises when released, decrease the tension.
• There are two types of counter balance and therefore two
methods of adjustment. Identify which counter balance is
present and adjust tension accordingly. Please note: if there
are 3 holes on the cable, use the cable to adjust; if there is
one hole on cable use the tub leg to adjust.
Figure H
7
Dishwasher Installation
CAUTION:
Do not remove wood base until you are ready to install
the dishwasher. The dishwasher will tip over when the
door is opened if the wood base is removed.
Figure G
STEP 2 – INSTALL TRIM PIECES
In this step, you will need the trim pieces set aside in Step 1.
• Press top trim piece onto top of tub fl ange. Start with the
right edge and work your way to the left.
• Repeat process with the left and right trim pieces working
from the top down.
• Open and close the door to check that trim does not bind and
does not interfere with door latch or door hinges.
Trim Strip
Trim
Strip
Trim
Strip
05A-1183U
Type 2
–
Three hole cable
Adjust tension by moving spring hook to one of the three holes
on the pulley cable.
Figure I
Increase
Tension
Decrease
Tension
Use This
Mounting
Hole
05A-1183P
After adjusting spring tension, open and close the door to
make sure the door operates smoothly. If the door is hard
to move or if the spring cable binds, check the routing of
the spring cable. The cable should be routed between the
shoulders of the pulley cable roller. If the cable is off the roller:
latch door, remove spring tension and route the cable between
the shoulders of the roller. See Figure J.
Type 1
–
One hole cable
Adjust tension by moving spring hook to one of the three holes
on the tub leg.
STEP 1 – LOCATE INSTALLATION ITEMS
• Locate the items in the installation package and set aside for
use in the listed steps.
• Trim pieces – Step 2
• Junction box cover – Step 7 or Step 18
• Drain hose and clamp – Step 10
• Screw Kit – Step 15
• Drain hose hanger – Step 17
• Owner’s Manual – Step 19 and Step 24
• Hard Water test strip – Step 21
• Sound upgrade kit (selected models) – Step 22
• Product samples and/or coupons – Step 24
Figure J
Correct Spring
Cable Routing
Shoulder
Pulley
Incorrect Spring
Cable Routing
