GE Optima XR200amx, Руководство по установке

Страница: 79 / 130

GE H
EALTHCARE
O
PTIMA
XR200
AMX
/XR220
AMX
D
IRECTION
5336113-1EN, R
EVISION
10 I
NSTALLATION
M
ANUAL
Chapter 4 Configuration Page 79
4.10.2.2 Verifying the default configuration
1. Turn on the system. Wait until the login screen appears.
2. Verify that a green LED is blinking on the barcode reader receiver.
3. Scan any barcode.
You will hear one set of high-low beeps. The scanned barcode characters appear in the Login
ID field on the login screen, and the cursor remains at the end of the scanned barcode.
The configuration is successful and the barcode reader is ready for use.
4. Replace the system covers.
4.10.2.3 Optional configuration 1
Optional configuration 1 is to add a Tab at the end instead of Return.
This configuration sets the barcode reader to add a Tab at the end of the scan instead of a Return.
Have a printed copy of these pages on hand so you can scan the necessary barcodes. If you make
a mistake during this configuration, start over at step 1.
1. Power up the system. Wait until the green LED on the receiver starts flashing.
2. Perform 4.10.2.1 Setting to default configuration on page 78 .
3. Scan the barcodes shown in Figure 4-7 , top to bottom.
After scanning each barcode you will hear one set of high-low-high beeps. The scanner will
beep at a one-second interval, and the LED will alternate green and red.
After scanning the last barcode, the scanner beam will turn off.
Figure 4-7 Set Tab at the end instead of Return
4.10.2.4 Verifying optional configuration 1
1. Turn on the system. Wait until the login screen appears.
2. Verify that a green LED is blinking on the barcode reader receiver.
3. Scan any barcode.
You will hear one set of high-low beeps. The scanned barcode characters appear in the Login
ID field on the login screen, and the cursor moves to the Password field.
The configuration is successful and the barcode reader is ready for use.
4. Replace the system covers.
SET
RZ
TAB
END