GE NETWORX NX-116E, Руководство пользователя

Страница: 14 / 20

12
TEST FUNCTION – Optional
If programmed, this function will perform a battery test, communicator test, and/or
a siren test. No alarms will be sent and no reports will be sent unless a
communicator test is performed, at which time a test signal will be sent.
Step 1
Press [
r
]-[4]. The test will be performed as programmed.
Step 2
If the siren test is performed, enter a user code to silence the siren.
WALK TEST
If enabled, it will permit a temporary walk-through test where all zones become
silent and do not report alarms to the central station.
Step 1 Press [
r
]-[Chime]-[user code]. During this test the chime light will
flash on the LED keypad.
Step 2 Each time a zone is faulted, the zone light on the LED keypad will
illuminate and the chime will sound. The number of the faulted
zone(s) will be displayed on the LCD keypad. It will also be entered
into alarm memory and the internal log.
Step 3 The keypad will begin to beep after 15 minutes in this mode. This
beeping indicates that the “Walk-Test” mode will be automatically
exited in 5 minutes.
Step 4 To exit at any time during this mode, enter a user code. Otherwise
the
A
Walk-Test Mode
@
will automatically exit after 20 minutes.
RESET FUNCTION
This function is used to reset Smoke Detectors, Zone Troubles, and Zone
Tampers.
Step 1 Disarm the system if not disarmed.
Step 2
Press [
r
]-[7]. Resets have now been performed.
Step 3
If the keypad begins beeping, the reset did not execute properly.
Enter your code to silence the keypad. Wait a few minutes and
repeat step 2 to attempt another reset. If the keypad still beeps after
repeated attempts, please contact your installer.
SETTING THE SYSTEM DATE
Step 1 Press the [
r
]-[9]-[6].
Step 2
Enter the “Master Code”.