![GE Monogram ZFSB27DASS Скачать руководство пользователя страница 18](http://html.mh-extra.com/html/ge/monogram-zfsb27dass/monogram-zfsb27dass_use-and-care-manual_2204227018.webp)
Preparation
Stainless Steel Refrigerator
Rollers
The rollers have 3 purposes:
1.
Rollers adjust so the door closes easily when
opened about halfway. [Raise the front about
5/8
²
(15 mm) from the floor.]
To assure that the doors will close automatically
from a halfway open position, there is a built-in
tilt from the front to the back of the cabinet.
Side-by-side refrigerators also have specially
designed door hinges that lift both doors
slightly when opened, allowing the force of
gravity to help close them securely.
2.
Rollers adjust so the refrigerator is firmly
positioned on the floor and does not wobble.
3.
Rollers allow you to move the refrigerator
away from the wall for cleaning.
To adjust the rollers,
remove the base grille by
pulling it out at the bottom.
Turn the roller adjusting screws
clockwise to
raise
the refrigerator,
counterclockwise to lower
it. Use an adjustable wrench (3/8
²
hex head
bolt) or pliers.
To replace base grille,
align prongs on back of
grille with clamps in cabinet and push forward
until grille snaps into place.
Refrigerator
location
Do not install refrigerator where temperature
will be below 60°F (16°C)
because it will not
run often enough to maintain proper
temperatures.
Do install it on a floor strong enough to
support a fully loaded refrigerator.
Clearances
Allow the following clearances for ease of
installation, proper air circulation, plumbing
and electrical connections.
Sides . . . . . . . . . . . . . . . . . . . . . .5/8
²
(15 mm)
Top . . . . . . . . . . . . . . . . . . . . . . .1
²
(25 mm)
Back . . . . . . . . . . . . . . . . . . . . . .1
²
(25 mm)
If the refrigerator is against a wall on either
side, allow 1
1
/
2
²
(38 mm) for door clearances.
Water supply
to icemaker
(on some models)
If your refrigerator has an icemaker, it will have
to be connected to a cold water line. A water
supply kit (containing copper tubing, shutoff
valve, fittings and instructions) is available at
extra cost from your dealer or from Parts and
Accessories, 800-626-2002.
There should be sufficient tubing for the
icemaker from the cold water supply to allow
you to move the refrigerator out from the wall
several feet [approximately 8 feet (244 cm) of
1/4
²
copper tubing in three 10-inch (25 cm)
diameter coils].
18