– 11 –
Fill Funnel
The top section of the fi ll funnel separates from
the main body. The fi ll funnel body is held in place
by a nut (located on the inside of the dishwasher).
Rotate the nut counterclockwise to remove the
main body. There is an O-ring seal be tween the
fi ll funnel and dish wash er tub. Make certain the
O-ring is fully seated when reinstalling.
Main Conduit
The main conduit supplies water to the middle
and upper spray wash arms.
Removal and Replacement
1. Pull the upper rack out.
2. Push the tab on the outer slide cap in and
remove the slide cap.
3. Remove the upper basket.
4. Release the bottom conduit tab.
5. Release the 2 center conduit tabs, then
remove the main conduit.
Upper Spray Arm
Check the holes in spray wash arm for bits of
china, seeds, and other foreign matter. Also,
check the spray arm for rotation.
To remove the upper spray wash arm, remove the
upper basket (See
Middle Spray Wash Arm
),
then
remove the screw and upper spray wash arm.
Lower Spray Arm, Fine Filter, and Inlet
Cover
Check the holes in the spray arm for bits of china,
seeds, and other foreign matter. Also check the
spray arm for rotation. If soil is present, clean fi ne
fi lter screen.
The lower spray arm can be removed by gently
lifting and rotating it coun ter clock wise.
The nut hub can be removed by rotating it
counterclockwise.
Caution:
Use care to avoid breaking the clip on
the hub when removing the main conduit from
hub.
Note:
When installing the fi ne fi lter, make sure
the drain port of the fi lter is engaged with the
drain for the fi ne fi lter.
O-ring
Nut
Lower
Spray Arm
Nut Hub
Cover Inlet
Hub
Float Dome
Coarse Filter
Fine Filter
Drain Port
Fine Filter
Assembly
Main Conduit
Mounting Screw
Main Conduit
Drain For
Fine Filter
Main Conduit
Tab
