GE LOGIQ F Series, Базовое руководство по обслуживанию

Страница: 34 / 167

GE LOGIQ F S
ERIES
D
IRECTION
5446617-100, R
EVISION
10 B
ASIC
S
ERVICE
M
ANUAL
1 - 8 Section 1-3 - Safety Considerations
Section 1-3
Safety Considerations
1-3-1 Introduction
The following safety precautions must be observed during all phases of operation, service and repair of
this equipment. Failure to comply with these precautions or with specific warnings elsewhere in this
manual, violates safety standards of design, manufacture and intended use of the equipment.
1-3-2 Human Safety
Servicing should be performed by authorized personnel only.
Only personnel who have participated in a LOGIQ F Series Training are authorized to service the
equipment.
1-3-3 Mechanical Safety
WARNING
WHEN THE UNIT IS RAISED FOR A REPAIR OR MOVED ALONG ANY INCLINE, USE
EXTREME CAUTION SINCE IT MAY BECOME UNSTABLE AND TIP OVER.
WARNING
ULTRASOUND PROBES ARE HIGHLY SENSITIVE MEDICAL INSTRUMENTS THAT
CAN EASILY BE DAMAGED BY IMPROPER HANDLING. USE CARE WHEN
HANDLING AND PROTECT FROM DAMAGE WHEN NOT IN USE. DO NOT USE A
DAMAGED OR DEFECTIVE PROBE. FAILURE TO FOLLOW THESE PRECAUTIONS
CAN RESULT IN SERIOUS INJURY AND EQUIPMENT DAMAGE.
WARNING
NEVER USE A PROBE THAT HAS FALLEN TO THE FLOOR. EVEN IF IT LOOKS OK,
IT MAY BE DAMAGED.
CAUTION
The LOGIQ F Series weighs 65 kg or more, depending on installed peripherals, when ready
for use. Care must be used when moving it or replacing its parts. Failure to follow the
precautions listed could result in injury, uncontrolled motion and costly damage.
ALWAYS:
Be sure the pathway is clear.
Use slow, careful motions.
Use two people when moving on inclines or lifting more than 65 kg (144 lbs).
WARNING
AFTER UNPLUG POWER CORD, WAIT FOR AT LEAST 20 SECONDS FOR
CAPACITORS TO DISCHARGE AS THERE ARE NO TEST POINTS TO VERIFY
ISOLATION.