EXCLUSIVE DISTRIBUTOR OF
U0806
Side-by-side Fridge
SPECIFICATIONS
General Electric Profile Arctica
Model 23
2EATTACHTHEACCESSCOVER
4YPICAL
#OMPRESSION
.UT
4UBING
#LAMP
4UBING
&ERRULE
SLEEVE
2EFRIGERATOR
#ONNECTION
4UBING
4UBING#LAMP
4YPICAL
#OMPRESSION.UT
&ERRULE
SLEEVE
2EFRIGERATOR#ONNECTION
0OWER
SWITCH
CONNECT THE TUBING TO THE REFRIGERATOR
NOTES:
• Before making the connection to the refrigerator, be sure the refrigerator power cord is not
plugged into the wall outlet.
• We recommend installing a water filter if your water supply has sand or particles that could
clog the screen of the refrigerators water valve. Install it in the water line near the refrigerator.
Some models have the refrigerator connection at the end of
tubing located outside the compressor compartment access
cover. On other models the compressor compartment access
cover must be removed in order to access the refrigerator
connection at the water valve.
On models using the refrigeration connection at the water valve, remove the plastic flexible cap.
Place the compression nut and ferrule (sleeve) onto the end of the tubing as
shown.
Insert the end of the tubing into the water valve connection as far as
possible. While holding the tubing, tighten the fitting.
Fasten the tubing into the clamp provided to hold it in a vertical position.
You may need to pry open the clamp.
One of the illustrations adjacent will look like the connection on your
icemaker.
Reattach the access cover.
TURN THE WATER ON AND PLUG IN THE REFRIGERATOR
Arrange the coil of tubing so that it does not vibrate against the back of the
refrigerator or against the wall. Push the refrigerator back to the wall. Adjustable
ROLLERS
are fitted with all GE refrigerators, these enable the fridge doors to be
aligned and ensure the refrigerator is firmly positioned on the floor, also allowing
the fridge to be moved away from the wall for cleaning. Final adjustments of your
fridge will be completed by your qualified Kleenmaid Installer.
START THE ICEMAKER
Set the icemaker power switch to the l position. The icemaker will not begin to
operate until it reaches its operating temperature of -9°C or below. It will then
begin operation automatically if the icemaker power switch is in the / position.
NOTE:
In lower water pressure conditions, the water valve may turn on up to 3
times to deliver enough water to the icemaker.
INSTALLING THE WATER LINE
9518 GEspecs PIG23.indd 2
21/8/06 11:52:38 AM
