Installation Instructions
4
1 Ft = 0.3 m
1” = 2.5 cm
CHECK LEVELING
Check the leveling by placing a level at the front and
sides of the microwave. It may be necessary to add wood
shims under the bottom duct to level the microwave
front-to-back or side-to-side.
7
INSTALL THE BOTTOM BRACKET
Install by placing the bottom bracket on the front of the
base pan and flush with the bottom of the oven. Align
the two screw holes, and drive two screws (D) through
the bottom bracket into the base pan.
8
Screw D
SECURE THE TOP AND BOTTOM
BRACKETS TO THE CABINET
Ensure the top and bottom bracket front flanges are tight
against the cabinet, and that the screw holes are aligned.
Drive 4 screws (E) through the top and bottom brackets
into the cabinet.
9
Screw E
INSTALL THE TRIM KIT FRAME
Position the assembled Trim Kit frame around
the oven.
Open the oven door, and locate the 4 screw
holes (two on the top and two on the bottom
edge of the door frame).
Secure the Trim Kit by driving four screws (C)
through the oven into the Trim Kit.
10
A
B
C
CAUTION!
Start all screws before tightening any
one screw. Do not overtighten screws since it can cause
misalignment of top/side strips.
Screw C
REPLACE ANY LOOSE ITEMS
Your trim kit is now fully installed. Replace the
turntable and turntable support that was
removed from inside the microwave oven.
Keep these installation instructions and extra
screws for future reference and need. Do not
place them in the microwave oven.
Replace the house fuse, or close the circuit
breaker to restore power at the service panel.
11
A
B
C
WARNING!
If the Side Bracket is removed from the
oven for usage without the trim kit, hazardous situations
can be avoided by reinstalling Screw B into the hole
between the louvers on the side of the oven.
READ CAREFULLY.
KEEP THESE INSTRUCTIONS
350A4502P609
49-40554
05-07 ATS
Printed In Malysia
