Safety InstructionsSafety Instructions
Operating
Instructions
Car
e and Cleaning
Tr
oubleshooting Tips
Consumer S
uppor
t
GEAppliances.com
Problem
Possible Causes
What To Do
Storage drawer
Rear drawer support is
•
Reposition the drawer. See the
Storage Drawer
is crooked
on top of the guide rail.
Removal
instructions in the
Care and cleaning
of the range
section.
Storage drawer
Power cord may be
•
Reposition the drawer and power cord. See the
won’t close
obstructing drawer
Storage Drawer Removal
instructions in the
Care and
in the lower back
cleaning of the range
section.
of the range.
Rear drawer support is
•
Reposition the drawer. See the
Storage Drawer
on top of the guide rail.
Removal
instructions in the
Care and cleaning of the
range
section.
Oven will not self-clean
The oven temperature is
•
Allow the oven to cool to room temperature and
too high to set a self-clean
reset the controls.
operation.
Oven controls improperly set.
•
See the
Using the self-cleaning oven
section.
Oven door is not in the locked
•
Make sure you move the door latch handle all the
position.
way to the right.
“Crackling” or
This is the sound of the
•
This is normal.
“popping” sound
metal heating and cooling
during both the cooking and
cleaning functions.
Excessive smoking
Excessive soil.
•
Touch the
Clear/Off
pad. Open the windows to
during a clean cycle
rid the room of smoke. Wait until the light on the
Self Clean
pad goes off. Wipe up the excess soil and
reset the clean cycle.
Oven door will not
Oven too hot.
•
Allow the oven to cool below locking temperature.
unlock
Oven not clean after
Oven controls not properly set.
•
See the
Using the self-cleaning oven
section.
a clean cycle
Oven was heavily soiled.
•
Clean up heavy spillovers before starting the clean
cycle. Heavily soiled ovens may need to self-clean
again or for a longer period of time.
“F –” and a number
You have a function
•
Disconnect all power to the range for at least
or letter flash
error code.
30 seconds and then reconnect power. If the function
in the display
error code repeats, call for service.
•
On self-cleaning models, if a function error code
appears during the self-cleaning cycle, check the oven
door latch. The latch may have been moved, if only
slightly, from the locked position. Make sure the latch
is moved to the right as far as it will go. Touch the
Clear/Off
pad. Allow the oven to cool for one hour.
Put the oven back into operation.
Water remaining on
This is normal.
•
Remove any remaining water with a dry cloth
oven floor after Steam
or sponge.
Clean cycle
35
