GE JSP26, Инструкция по использованию и уходу

Страница: 24 / 36

OPERATING THE SELF-CLEANING OVEN
(continued)
How to Set Oven for Cleaning
Quick Reminder:
1.
Press the CLEAN pad.
2. Press the INCREASE or DECREASE pad
until the desired Clean Time appears.
the oven is too hot and you start to set a clean
cycle, the word “OFF” will appear in the display.
Allow additional time for cooling before you try to
set the cycle.
1.
Follow the steps in the Before a Clean Cycle
section.
2. After closing the door, press the
CLEAN
CLEAN pad.
3. Press the INCREASE or DECREASE
displayed.
u
Clean Time is normally 3 hours.
You can change the Clean Time to
depending on how dirty your oven is.
The self-clean cycle will automatically begin after
“CLEAN” is displayed and the
“ON” appears in
the display. When the oven heats to a high temperature,
the word “LOCK” will appear in the display. It will not
be possible to open the oven door until the temperature
drops below the lock temperature and the LOCK light
goes off.
4. When the LOCK light is off, open the door.
NOTE:
●
You can find out when the clean cycle will be
finished by pressing the STOP TIME button.
●
The word “door” will be displayed, the word
“LOCK” will flash and oven control will signal if you
set the clean cycle and forget to close the oven door.
●
A fan may automatically turn on and off to cool
internal parts. This is normal, and the fan may
continue to run after the oven is turned off.
To Stop a Clean Cycle
1. Press the pad.
2. When the LOCK light goes off and the oven has
CLEAR
cooled below the locking temperature, open the door.
24