Consumer
S
uppor
t
Tr
oubleshooting
Tips
Installation
Instructions
Car
e
and
Cleaning
Operating
Instructions
Safety
Instructions
10
Installation of the cooktop.
Read these instructions completely and carefully.
Tools You Will Need
■
1/8
″
Drill bit
■
Electric or hand drill
■
Flat blade screwdriver
■
Pencil
■
Ruler or tape measure and straightedge
■
Hand saw or saber saw
Before You Begin
Read these instructions completely
and carefully.
IMPORTANT—
Save these instructions
for local inspector’s use.
IMPORTANT—
Observe all governing codes
and ordinances.
NOTE TO INSTALLER—
Be sure to leave these
instructions with the Consumer.
NOTE: This appliance must be properly
grounded.
Electrical Requirements
CAUTION:
for personal safety, remove
house fuse or circuit breaker before beginning
installation.
This appliance must be supplied with the proper
voltage and frequency and connected to an
individual, properly grounded branch circuit,
protected by a circuit breaker or time delay fuse,
as noted on the rating plate.
All wire connections must be made in accordance
with local codes and properly insulated. Check with
your local utility for governing electrical codes and
ordinances.
In the absence of local electrical codes, the
National Electrical Code, ANSI/NFPA No. 70–Latest
Edition, governing electric range installations, must
be followed.
A copy of the National Electrical Code can be
obtained by writing to:
National Fire Protection Association
Batterymarch Park
Quincy, MA 02260
If you fail to wire your counter unit in
accordance with governing codes, you
may create a hazardous condition.
Electrical Connections
DANGER:
The electrical power to
the counter unit supply line must be shut off
while line connections are being made. Failure
to do so could result in serious injury or death.
You must use a two-wire A.C. 208/240 Volt,
60 Hertz electrical system. A white (neutral) wire is
not needed for this unit. The white lead from the
household electrical supply can be isolated and
secured in the junction box.
If you connect
to aluminum wiring, properly installed
connections listed for use with aluminum
and copper wiring must be used.
Use a minimum wire size of No. 12 copper wire
with a 20 Amp fuse or circuit breaker for both
208/240 Volt electrical systems.
When making the wire connections, use the entire
length of conduit provided. The conduit must not
be cut.
Connect the red and black leads from the counter
unit conduit to the corresponding leads in the
junction box.
The bare ground wire in the conduit is connected to
the counter unit frame. It must be connected to the
household electrical supply ground.
Rating plate is
located on the
bottom center front
of the cooktop
