6
Installation Instructions
Cutout for Built-In Oven with
Microwave models only – Over
a Warming Drawer
For JKP90, JTP90, PT970 models only.
A
30
″
(76.2 cm) Oven with
Microwave Oven (Models
JTP90 and PT970) Over a
Warming Drawer
Anti-Tip Block
Against Rear
Wall Per Warming
Drawer Requirement
2
”
(5.1 cm)
Min.
1
”
(2.5 cm) Min. Above Toekick
Per Warming
Drawer
Requirement
Anti-Tip Block
Against Rear
Wall Per
Warming Drawer
Requirement
2
”
(5.1 cm)
Min.
1
”
(2.5 cm) Min. Above Toekick
Per Warming
Drawer
Requirement
27
″
(68.6 cm) Oven with
Microwave Oven (Model
JKP90) Over a Warming
Drawer
NOTE: Additional clearances between cutouts
may be required. Check to be sure the oven
supports above the Warming Drawer location
do not obstruct the required interior depth and
height.
• When installing a Warming Drawer below
a single or double oven, a separate 120V,
60 Hz, properly grounded receptacle must
be installed. Refer to installation instructions
packed with the Warming Drawer for
specific installation requirements.
NOTE: Install the
oven only with
specific models
listed on the label
located on top of
the oven.
