Safety Instructions
Operating Instructions
Care and Cleaning
Troubleshooting T
ips
Customer Service
Broiler Pan & Grid
Do not clean the broiler pan or grid in a self-
cleaning oven.
After broiling, remove the broiler pan
from the oven. Remove the grid from the
pan. Carefully pour out the grease from
the pan into a proper container.
Wash and rinse the broiler pan and grid
in hot water with a soap-filled or plastic
scouring pad.
If food has burned on, sprinkle the grid
with detergent while hot and cover with
wet paper towels or a dishcloth. Soaking
the pan will remove burned-on foods.
Both the broiler pan and grid may be
cleaned with a commercial oven cleaner.
Both the broiler pan and grid can also be
cleaned in a dishwasher.
Do not store a soiled broiler pan and grid
anywhere in the range.
After broiling, remove the broiler
pan from the oven.
Removable Oven Bottom
The oven bottom can be removed to
clean large spills, and to enable you to
reach the oven burner.
The oven bottom must be replaced before using
the self-clean cycle.
To remove:
Slide the tab at the center front of
the oven bottom to the left.
Lift the oven bottom up and out.
To replace:
Slip the oven bottom into the oven so
the tabs in the rear of the oven bottom
fit into the slots in the oven back.
Lower the front of the oven bottom
into place and slide the front tab to
the right to lock the oven bottom
into place.
The oven bottom has a porcelain enamel finish.
To make cleaning easier, protect the oven bottom
from excessive spillovers.
Hot fruit fillings or foods that are acidic
(such as tomatoes or sauerkraut, and
sauces with vinegar or lemon juice) may
cause pitting and damage to the
porcelain enamel surface.
To protect the oven bottom surface, place
a piece of aluminum foil slightly larger
than the baking dish or a small cookie
sheet on a lower shelf or under the baking
dish to catch any spillovers.
Do not completely cover a shelf with aluminum
foil as this would cause uneven heat in the oven.
Aluminum foil should not be placed on the oven
bottom.
If a spillover does occur on the oven
bottom, allow the oven to cool first. You
can clean the oven bottom with soap and
water, a mild abrasive cleanser or soap-
filled abrasive pads. Rinse well to remove
any soap before self-cleaning.
The tab at the center front of the
oven bottom slides left to unlock
and right to lock.
The light cover assembly has a
cover ring, crystal and gasket. It is
held in place with 3 screws.
Oven Light Bulb
The light bulb is located on the back
oven wall. Before replacing the bulb,
disconnect the electric power to the range
at the main fuse or circuit breaker panel
or unplug the range from the electric
outlet.
Let the bulb cool completely before removing it.
Do not touch a hot bulb with a damp cloth. If you
do, the bulb will break.
To remove:
Remove the 3 screws in the cover
ring.
Detach the light cover assembly and
remove the bulb.
To replace:
Put in a new 40-watt appliance bulb.
NOTE:
A 40-watt appliance bulb is smaller than a
standard 40-watt household bulb.
Install the light cover assembly.
Replace the 3 screws and tighten,
making sure the cover fits flush with
the oven wall.
Reconnect the electric power to
the range.
Unlock
Bulb
Gasket
Cover ring
Crystal
3 Screws
Lock
25
