CONVERT THE PRESSURE
REGULATOR
Locate the pressure regulator under the front of
the cooktop.
Remove the nut from the pressure regulator with
an adjustable wrench.
Remove the plastic pin from the inside of the
nut, turn the pin 180° and snap the pin back
into the nut.
Re-install the nut onto the regulator.
Apply the LP Conversion label next to the
Rating Plate.
E
D
C
B
A
1
2
LP Conversion Instructions
Nut
Natural gas
LP gas
Nut
Natural gas
LP gas
GAS SUPPLY
•
With the installation of this conversion kit, the cooktop
should operate on LP gas at 10
″
of water column
pressure.
•
The pressure regulator must be connected in series
with the manifold of the cooktop and must remain in
series with the supply line. For proper operation, the
maximum inlet pressure to the regulator must be no
more than 14
″
water column pressure for LP gas.
•
When checking the regulator, the inlet pressure must
be at least 1
″
greater than the regulator output setting.
If the regulator is set for 10
″
of water column pressure,
the inlet pressure must be at least 11.
″
IMPORTANT –
Disconnect the cooktop
and the individual shut-off valve from the gas supply piping
system during any pressure testing of that system at test
pressures greater than 1/2 psig. Isolate the cooktop from
the gas supply piping system by closing the individual
manual shut-off valve to the cooktop during any pressure
testing of the gas supply piping system at test pressures
equal to or greater than 1/2 psig.
TURN OFF GAS AND
ELECTRIC SUPPLY
BEFORE YOU BEGIN, TURN OFF THE GAS SUPPLY
AT THE SHUT-OFF VALVE. DISCONNECT THE
ELECTRICAL SUPPLY FROM THE COOKTOP.
Shut-off valve
Electrical supply
