Safety Instructions
Operating Instructions
Safety Instructions
Operating Instructions
Care and Cleaning
Tr
oubleshooting T
ips
Consumer Support
Using the surface units.
ge.com
Throughout this manual, features and appearance may vary from your model.
How to Set
Push the knob in and turn in either direction
to the setting you want.
At both
OFF
and
HI
the control
clicks
into
position. You may hear slight
clicking
sounds
during cooking, indicating the control is
keeping the power level you set.
The appropriate
HOT SURFACE
indicator light
will glow when its corresponding radiant element
is turned on and will remain on until the surface
has cooled below 150°F.
Hot surface indicator light will:
■
Come on when the surface unit is turned on.
■
Stay on even after the unit is turned off.
■
Glow until unit has cooled below 150°F.
Be sure you turn the control knob to OFF
when you finish cooking.
Dual Surface Unit Control Knob
The dual surface unit has 2 cooking sizes to select from
so you can match the size of the unit to the size of the
cookware you are using.
To use the small surface unit, turn the control
knob to the
SMALL BURNER
settings.
To use the large surface unit, turn the control
knob to the
LARGE BURNER
settings.
7
Tri-Ring Surface Element
(on some models)
The rear center surface element offers 3 cooking areas
to match the size of the cookware you are using.
To use the largest cooking area, push in and
turn the
SELECTOR
knob to 12
″
. Push and
turn the control knob to the desired setting.
To use the medium cooking area, press and
turn the
SELECTOR
knob to 9
″
.
Push down and turn the control knob to the
desired setting.
To use the smallest cooking area, turn the
SELECTOR
knob to 6
″
. Push and turn the
control knob to the desired setting. This will
activate only the smallest inside heating area.
OFF
BURNER
SIZE
6"
9"
12"
Using the Bridge Burner
(on some models)
To use the bridge burner, turn the left front
control knob to the
BRIDGE BURNER
settings.
For full bridge surface unit operation, also
turn on the left rear surface unit.
To use only the front surface unit, turn the
control knob to the
FRONT BURNER
settings.