GE IM4D, Руководство пользователя и инструкции по установке

Страница: 16 / 68

BEFORE YOU BEGIN
Read each step thoroughly before proceeding.
•
WARNING
To eliminate the
risk of electric shock or injury during
installation, you must first unplug the
refrigerator before proceeding. Failure
to follow these instructions can result
in electrical shock.
WATER VALVE ASSEMBLY INSTALLATION INSTRUCTIONS T
Flat blade and Phillips
screwdrivers
Pliers
TOOLS YOU WILL NEED
Sharp knife
1/4" and 5/16" Nutdrivers
ATTACH THE BRACKET EXTENSION
TO THE WATER VALVE
‡ 8VHDµQXWGULYHUWRDWWDFKWKHEUDFNHWH[WHQVLRQ
(16) to the water valve bracket with the screw (17).
3
REMOVE THE COVER
Use a 5/16" nutdriver or an adjustable wrench to
remove the compressor compartment access cover.
7KLVUHTXLUHVUHPRYLQJVL[VFUHZVZKLFKDWWDFKWKH
cover to the back of the refrigerator case.
Be sure to save the screws as the access cover
must be reinstalled later to ensure your refrigerator
will function properly.
1
PLASTIC WATER TUBING
• Remove water line from the valve assembly (3)
included in this kit by removing the tube from the
clip and pushing on the bottom of the valve quick-
connect, disengaging the tube and pulling it from
the valve.
• Use the water line from the fill tube assembly
that came with the refigerator. The water line is
attached to the fill tube assembly that is already
installed in the refrigerator. Remove the plug from
the end of the waterline. Route the water line
through the clip on the valve pushing it into the
quick-connect on the valve. The white line will be
barely visible if properly engaged.
2
Push up
Quick-connect
Quick-connect
Pull down
Clip
Clip
Water line
Water line
%UDFNHWH[WHQVLRQ
Installation Instructions
16
17
16