49-60704-2
21
INST
ALLA
TION INSTRUCTIONS
Installation Instructions
4
INSTALL WATER LINE CLAMP
Ŷ
Attach the
metal water line clamp
VWUDLQUHOLHI
WRWKHUHIULJHUDWRU'ULYHWKH
screw
IURP
the kit through the
clamp
DWWKHLQGHQWLQWR
the back of the cabinet.
Ŷ 7KHPHWDOFODPSLVIRUWKHKRXVHZDWHUOLQHVHH
WKH:DWHU/LQH,QVWDOODWLRQ,QVWUXFWLRQV,WLVQRWWR
be used for the tubing from the water valve up to
the icemaker.
6
ROUTE AND ATTACH THE
PLASTIC WATER LINE
Ŷ
Fasten the plastic water line to the back of the
cabinet with
adhesive-backed fasteners
spacing the fasteners as shown to take up slack in
the line.
7
WATER VALVE INSTALLED
Ŷ 5HIHUWRWKH:DWHU/LQH,QVWDOODWLRQ,QVWUXFWLRQVIRU
connection to the home water supply. After water
line installation is completed, set the icemaker
power switch to
ON
.
Ŷ
The icemaking cycle will not begin until the
icemaker and freezer compartment reach
operating temperature, then icemaking will
begin automatically.
5
CONNECT THE WATER LINE
Ŷ
Make sure there is enough plastic water line to
extend from the water valve to well into the
water
tube inlet
&XWRIIDQ\H[FHVVWXELQJ
Ŷ 6TXHH]HWKHHQGVRIWKH
hose clamp
IURPWKH
kit with pliers and slide the clamp over the water
tube inlet.
Ŷ :KLOHVWLOOVTXHH]LQJWKHFODPSLQVHUWWKH
plastic water line into the inlet as far as it will go
DSSUR[LPDWHO\>PP@
Ŷ
Then slide the clamp downward to capture the
plastic water line in place.
8
REINSTALL THE COVER
Ŷ
Reinstall the compressor compartment access
FRYHU7KLVUHTXLUHVXVLQJWKHVFUHZV\RX
removed previously to reattach the cover to
the back of the refrigerator case. This must be
reinstalled for your refrigerator to function properly.
7
17
3
Water tube
inlet
Adhesive-backed fasteners
for plastic water line
WARNING
ELECTRIC SHOCK
HAZARD
Attach tubing clamp using existing hole only. DO
NOT drill into the refrigerator.
