GE IC754VGI06SKD, Руководство пользователя

Страница: 53 / 78

D e t a i l e d O p e r a t i o n
Ethernet
GFK-2357A 6" QuickPanel View Keypad
45
E T H E R N E T
The QuickPanel View Keypad is equipped with an auto-negotiate, full or half
duplex Ethernet port (IEEE802.3). You can connect an Ethernet network cable
(unshielded, twisted pair, UTP CAT 5) to the unit via the RJ45 connector on the
bottom of the enclosure. LED indicators on the port indicate channel status. Access
to the port is possible either by Windows CE network communications, or by your
custom application. The following diagram shows the location, orientation, and
pin out of the Ethernet port.
There are two methods for setting an IP address on the QuickPanel View Keypad:
■
DHCP (Dynamic Host Configuration Protocol). Using this method uniquely
specify the numeric addresses for the QuickPanel View, the Subnet Mask and
the Default Gateway (if applicable).
Note: There must be a DHCP server on the connected network for a valid IP
address to be assigned. Contact your network administrator to ensure correct
DHCP server configuration.
■
Manual method. Using this method uniquely specify the numeric addresses for
the QuickPanel View Keypad, the Subnet Mask, and the Default Gateway (if
applicable).
Note: Use a crossover cable to connect the QuickPanel View Keypad to a PC
directly; when connecting to a LAN HUB, use a straight through cable.
Contact your network administrator if you require further information.
1 TX_D1 +
2 TX_D1 -
3 RX_D2 +
4 B1_D3 +
5 B1_D3 -
6 RX_D2 -
7 B1_D4 +
8 B1_D4 -
Bottom
Ethernet Port
LAN1: 10/100Mb
Activity LED
(on: packet received
or transmitted)
Link LED
(on: channel
connected ok)