20
SET SALT LEVEL
1. Press the
MODE/SET
button until the arrow
points to
SALT LEVEL.
2. Determine level of salt in brine tank using the
numbered scale on side of brine well, inside
brine tank (see Figure 15).
3.
Press UP
or DOWN
button to set
the
SALT LEVEL
to correspond to level on
the numbered scale in brine tank.
NOTE:
Each press of a button changes the
level by increments of 0.5 up to 8.0.
Lowering the salt level below zero turns the
SALT LEVEL
indicator OFF.
4.
Press the
MODE/SET
button to accept. The
display shows the present time of day and
DAYS TO EMPTY.
DAYS TO EMPTY
The words
DAYS TO EMPTY
and a number
are shown in the lower half of the display. This
information is shown in the normal run display.
This is to inform the user of the number of
days before the salt level in the brine tank
reaches Level 0. There will be salt left in the
salt tank, but it may not be sufficient to fully
recharge the system. Salt should be added
at this time to avoid hard water. The value is
updated daily and whenever the
SALT LEVEL
value is changed.
NOTE:
For the first several weeks of operation,
the
DAYS TO EMPTY
may provide erratic
operation. For example, the blue indicator light
may flash, showing that more salt is required
when the actual salt level in the tank is well
above the Level 0. In some cases, the
DAYS
TO EMPTY
may even increase over a several
week period.
It takes a couple of months for the water
softener to learn
your
water usage pattern.
Once it does this, it will accurately determine
actual salt usage pattern. During this first
period, check salt level when blue indicator
light flashes. If the salt level in the tank is at
Level 1 or above, allow system to run. Be sure
to reset your salt level indicator each time you
add salt to the system.
START A RECHARGE
Press the
RECHARGE
button and hold for
three seconds, until “RECHARGE NOW”
begins to flash in the display, starting a
recharge. This recharge draws the sanitizing
bleach or brine into and through the water
softener. Any air remaining in the water
softener is purged to the drain. During this time
periodically check for leaks.
NOTE:
As with all other water system
applications, leaks may occur. Leaks may not
be immediately apparent. Recheck 24 hours
after first recharge cycle is complete.
Salt Level
Clock
Hardness
Recharge
Salt Level
Clock
Hardness
Recharge
PM
Days to Empty
AM
Days to Empty
8
7
6
5
4
3
2
1
Figure 15
Programming the Water Softener
Содержание GXSHC40N
Страница 34: ...34 8 7 6 5 11 16 146 5 999 29 4 41 40 42 12 2 13 3 7 8 9 10 56 56 17 19 20 22 23 23 24 30 6 26 Exploded View ...
Страница 41: ...41 Notes ...
Страница 76: ...76 Vista Expandida 8 7 6 5 11 16 146 5 999 29 4 41 40 42 12 2 13 3 7 8 9 10 56 56 17 19 20 22 23 23 24 30 6 26 ...
Страница 83: ...83 Notas ...