29-6435
9
Getting started - Washer
USING THE
W
ASHER
Consumer Help Indicator
Your washer is equipped with Consumer Help Indicator (CHI). CHI is our way to communicate a simple remedy for some
situations that you can perform without the need to call for service. The chart below describes the helpful lights you may
notice flashing on the display.
Spin
and
Rinse
lights blinking
If an out-of-balance condition is detected by the washer, the
Spin
and
Rinse
lights will blink during
the remaining portion of the cycle and will stay illuminated for a short time after cycle completion. When
this occurs, the washer is taking actions to correct the out-of-balance condition and complete the cycle
normally. In some cases, the washer may not be able to balance the load and spin up to full speed.
If you notice the load is more wet than normal at the end of the cycle, redistribute the load evenly in
the wash basket and run a
Drain & Spin
cycle.
Wash
and
Rinse
lights blinking
(Water not
entering washer)
Check your house water supply. Did you forget to turn on one or both supply valves after installation or
coming back from vacation? As soon as the lights start to flash, the washer will initiate a 4 minute lock-
out period. The washer controls won’t respond/change during this time. After the 4 minutes, you can
begin your cycle again. If you try to bypass the lock-out period by unplugging the washer, the 4 minute
timer will start over again.
Lid Locked
light
Lid Locked
light will flash if 3 cycles have been started without opening the lid. The washer will not
start another cycle until the lid is opened. Try opening, then closing the lid and starting a new cycle. If
the problem persists, call Call GE Appliances at 1.800.561.3344
WARNING
For waterproof, water-resistant items only use the Delicates cycle. DO NOT use other cycles for these items, for example: ski
clothing, diaper covers, bulky waterproof bed covers, umbrella covers, vehicle covers, sleeping bags, waterproof coats, etc).
In other cycles different to the one recommended, when the basket turns, it is possible that water gets trapped in waterproof
items and clothing, which can cause abnormal vibration and out-of-balance condition. Besides, the clothing moves upwards and
may be expelled, this may result in injury or damage to the washer, walls, floor, or clothing.DO NOT mix waterproof and
non-waterproof items.
REMOTE ENABLE
Hold both buttons for 3 seconds for start
Remote Enable
(LED Connected is on and
AP
appears blinking on the display).
When press Start button
AP
stops flashing and stays on, then from the app the user can modify the scheduled time from 24 to 00
hours or start the washer cycle.
NOTE:
This function is only for the washer cycles.
Cycle Options
G
The
Status lights
show the stage the washer is in. When the selector knob is set to a new cycle, the Status lights will flash
momentarily, showing the stages the cycle will go through.
Status light
Iluminates
Wash
When the washer is in the
wash stage
of the cycle.
Rinse
When the washer is in the
rinse stage
of the cycle.
Spin
When the washer is in the
spin stage
of the cycle.
