DEH-41318 Rev. 5 (07/10 M45)
imagination at work
These instructions do not cover all details or variations in equipment nor do they
provide for every possible contingency that may be met in connection with installation,
operation, or maintenance. Should further information be desired or should particular
problems arise that are not covered sufficiently for the purchaser’s purposes, the
matter should be referred to the GE Company.
GE Energy
41 Woodford Avenue, Plainville, CT 06062
www.geelectrical.com
© 2010 General Electric Company
Spectra and MicroVersaTrip are registered trademarks and EntelliGuard and
micro
EntelliGuard are trademarks of the General Electric Company.
UL Label
The UL label is mounted on the side of the rating plug
and is not visible when the rating plug is installed. The
label lists the circuit breaker frames that will accept
that rating plug.
Installation
Before installing a rating plug into an EntelliGuard TU trip
unit, inspect the plug for damage, then follow these steps:
1. Verify that the rating plug catalog number matches
the desired continuous current rating and is suitable
for the circuit breaker’s sensor based on the
minimum and maximum sensor rating defined on
the rating plug’s catalog number.
2. Hold the rating plug between the thumb and
forefinger, then push it into the trip unit. Proper
engagement is verified by an audible and tactile click.
CAUTION:
Do not attempt to push the rating plug into
the trip unit if there is resistance.
Removal
The rating plug is seated firmly in the trip unit. As
illustrated in Figure 1, there are tabs at the sides of
the rating plug for removal. A rating plug removal tool,
catalog number TRTOOL, also known as an integrated
circuit (DIP) extractor, is required to remove the rating
plug. Grasp the tabs of the rating plug with the tool,
as illustrated in Figure 2. Be careful to hold the tabs
and not the front cover, as the rating plug could be
damaged otherwise. Gently pry the rating plug out by
pulling away from the trip unit. A left–right wriggling
motion assists the removal. Insure that the tabs are held
securely until the Rating Plug is completely removed.
Figure 2. Rating plug removal
NOTE:
Protection to the breaker is maintained at the
minimum rating plug value for a particular sensor when
the rating plug is removed.
