GE GTH21GBEBB, Руководство пользователя и инструкции по установке

Страница: 15 / 96

15
Installation Instructions
REMOVE THE COVER
At the bottom rear of the refrigerator, remove the
screw(s) holding the access cover.
Bend the cover back for access to the compartment.
Be sure to save the screws as the access cover must be
reinstalled later to ensure your refrigerator will function
properly.
1
BEFORE YOU BEGIN
Read each step thoroughly before proceeding.
‡
CAUTION –
Unplug the
refrigerator. To eliminate the danger
RI HOHFWULF VKRFN GXULQJ LQVWDOODWLRQ
you must unplug the refrigerator from
its electrical outlet.
WATER VALVE ASSEMBLY INSTALLATION INSTRUCTIONS
Flat blade and Phillips
screwdrivers
Pliers
TOOLS YOU WILL NEED
6KDUSNQLIH
1/4” and 5/16” Nutdrivers
ATTACH THE WATER VALVE
‡/RFDWH WKH IHPDOH FRQQHFWRU SOXJ 3OXJ WKH
female
connector onto the PDOH WHUPLQDOV RQ WKH ZDWHU
YDOYH. Either wire can go on either terminal.
2
Female
connector
Male
terminals
FOR MODELS WITH ONE TEMPERATURE CONTROL
(REFRIGERATORS ONLY)
‡ )DVWHQWKHZDWHUYDOYHWRWKHFDELQHWE\GULYLQJWKH
KH[KHDGVFUHZ (10) from the kit into the hole in the
cabinet leg.
INSTALL WATER LINE CLAMP
‡
Attach the PHWDOZDWHUOLQHFODPS (strain relief) (6)
to the refrigerator. Drive the VFUHZ (5) from the kit
through the clamp (6) at the indent into the back of
the cabinet.
‡7KHPHWDOFODPSLVIRUWKHKRXVHZDWHUOLQHVHHWKH
Water Line Installation Instructions). It is not to be
used for the water tube from the water valve up to
the inlet.
4
5
6
CONNECT WATER TUBE TO INLET
‡
Squeeze the ends of the hose clamp (16) from the kit
with pliers and slide the clamp over the inlet, located
in the top right corner of the refrigerator.
‡
While still squeezing the clamp, insert the free end of the
ZDWHUWXEH (3) into the inlet as far as it will go.
‡
Then slide the clamp downward to capture the water
tube in place.
‡
Using one of the DGKHVLYHEDFNHGIDVWHQHUV (4), secure
the water tube to the back of the refrigerator about 1/2”
below the inlet.
16
4
Inlet
3
3
10